Gemalto CINTERION BGS2T - 7.6 ATD><str> Mobile originated call from active memory using corresponding field

BGS2T AT Command Set
7.6 ATD><str>
BGS2T_ATC_V01.301 Page 144 of 554 1/31/12
c
7.6 ATD><str> Mobile originated call from active memory using cor-
responding field
Syntax
Command Description
This command searches the active phonebook for a given string <str> and dials the assigned phone number.
The termination character ";" is mandatory since dialing from a phonebook is only supported for voice calls and
for sending *# codes of Supplementary Services or other functions.
Parameter Description
String type value ("x") that should equal an alphanumeric field in at least one phonebook entry in the searched
memories; used character set should be the one selected with AT+CSCS. <str> can contain escape sequences
as described in chapter "Supported character sets".
<str> must be wrapped in quotation marks (""), if escape sequences or parameter <mgsm> are used or if the
alphanumeric strings contains a blank. If not, quotation marks are optional. If AT+CSCS is set to "UCS2", with
respect to the coding of UCS2-characters only phonebook entries that contain an alphanumeric string with a
size less than the half of the parameter <tlength> from AT+CPBW can be dialed.
String of GSM modifiers:
I Activates CLIR (disables presentation of own phone number to called party, if no *#31#-code is within the
dial string)
i Deactivates CLIR (enables presentation of own phone number to called party, if no *#31#-code is within the
dial string)
Exec Command
ATD><str>[<mgsm>];
Response(s)
ERROR
+CME ERROR: <err>
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
NO DIALTONE
When TA returns to command mode after call release:
OK
If successfully connected:
OK
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
+ + + ± ± - - V.250
<str>
(str)(+CSCS)
<mgsm>
(str)
Confidential / Released