BGS2T AT Command Set
10.13 Examples of how to Configure and Use Internet Service Profiles
BGS2T_ATC_V01.301 Page 296 of 554 1/31/12
c
10.13.19 Server Disconnects While Transparent TCP Service is in AT
Command Mode
10.13.20 Server Disconnects While Transparent TCP Service is in AT
Command Mode and Data is Pending
at^siso=1
Open Transparent TCP service.
OK
^SISW: 1,1
URC indicates that Transparent TCP service is
ready.
^SIS: 1,0,15
<urcInfoId> 15: Remote host has reset the con-
nection. This means that the server has released the
connection to Transparent TCP Socket client.
^SIS: 1,0,19
<urcInfoId> 19: Socket has been shut down.
at^sisi?
Check service state of service profile 1.
^SISI: 1,6,0,0,0,0
Service is in service "Down" state (6). No data pend-
ing.
OK
at^sisc=1
Close the service.
OK
at^sisi=1
Check service state of service profile 1.
OK
^SISI: 1,2,0,0,0,0
Service profile 1 is in state "Allocated" (2).
at^siso=1
Open Transparent TCP service.
OK
^SISW: 1,1
URC indicates that Transparent TCP service is
ready.
^SIS: 1,0,15
<urcInfoId> 15: Remote host has reset the con-
nection. This means that the server has released the
connection to Transparent TCP Socket client.
^SIS: 1,0,19
<urcInfoId> 19: Socket has been shut down.
at^sisi?
Check service state of service profile 1.
^SISI: 1,5,0,0,0,0
Service is in service "Closing" state (5).
OK
at^sist=1
Open transparent access mode.
CONNECT
Service is ready to send or receive data.
...DATA...
Client is sending data.
+++
Client types +++ to return to AT command mode.
OK
at^sisc=1
Close the service.
OK
at^sisi=1
Check service state of service profile 1.
OK
^SISI: 1,2,0,0,0,0
Service profile 1 is in state "Allocated" (2).
OK
To Next Page
Loading...
Need help?
General
