BGS2T AT Command Set
15.22 AT^SSTGI
BGS2T_ATC_V01.301 Page 455 of 554 1/31/12
c
15.22 AT^SSTGI SAT Get Information - Language Notification (53)
This command shall be used after receiving the URC ^SSTN: 53.
It provides text to inform the TE about the language currently used for any text string within proactive commands
or envelope command responses.
The notified language remains valid until the end of the card session or upon executing another LANGUAGE
NOTIFICATION command.
If the Toolkit application is not aware of the currently selected language, no specific language or several lan-
guages will be used. The SIM may notify non-specific language. All LANGUAGE NOTIFICATION previously
made will be cancelled.
Two types of language notification are defined:
• specific, where a two-character language notification is issued in <langText>,
• non-specific, where no language notification is issued, i.e. <langText> is an empty string.
The TE may use the language included in LANGUAGE NOTIFICATION as appropriate. For instance, this could
be done to avoid a mix of languages in screen displays combining ME MMI and SIM Toolkit originating text
strings.
Syntax
Parameter Description
53 Proactive command ID, see Remote-SAT Command Types
0...255 Used as bit field
bit 1 0: non-specific language notification
1: specific language notification
bit 2-8 RFU
Language code string provided as a pair of alpha-numeric characters, defined in ISO 639. Each alphanumeric
character is coded on one byte using the SMS default 7-bit coded alphabet as defined in 3GPP TS 23.038[27].
Note
• AT^SSTGI can be issued during states IDLE, PAC and WAIT for this proactive command without previously
receiving a URC ^SSTN:<cmdType>, see AT^SSTGI.
Write Command
AT^SSTGI=53
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <langText>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<langText>
(str)
To Next Page
Loading...
Need help?
General
