BGS2T AT Command Set
8.19 AT^SNMON
BGS2T_ATC_V01.301 Page 209 of 554 1/31/12
c
8.19 AT^SNMON Network monitoring
The AT^SNMON command can be used to monitor various network information. Please note, that the write com-
mand only returns a line with the current parameter values, if is set to 2 (Query current values).
Syntax
Parameter Description
This parameter determines the action to be taken for the monitoring command.
0
(P)
Disable ^SNMON URC
1 Enable ^SNMON URC (currently not supported)
2 Query current values
Test Command
AT^SNMON=?
Response(s)
^SNMON: "INS", (list of supported <mode>s), (list of supported <rb>s)
OK
ERROR
+CME ERROR: <err>
Write Command
Start informal network scan.
AT^SNMON="INS", <mode>[, <rb>]
Response(s)
If <mode>= 0 or 1:
OK
ERROR
+CME ERROR: <err>
If <mode>= 2:
In case of <rb>= 1 .. 8:
^SNMON: "INS", <mode>, <rb>, <rat>, <cid>, <lac>, <plmn>, <arfcn>, <rssi>
In case of no cell found for specific band then all values behind <mode> will be omitted:
^SNMON: "INS", <mode>, <rb>
In case of <mode>= 0 or 1 only result code is presented
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - 3GPP TS 45.008 [39]
<mode>
(num)
To Next Page
Loading...
Need help?
General
