BGS2T AT Command Set
8.19 AT^SNMON
BGS2T_ATC_V01.301 Page 210 of 554 1/31/12
c
Radio Band
In the write command the parameter is the arithmetic sum of the radio bands to be scanned. In the response of
the read command this parameter determines the radio band of the cell that was scanned.
1GSM 900
2 GSM 1800
4GSM 850
8 GSM 1900
Radio Access Technology
Parameter determines the radio access technology of the cell that was scanned.
0GSM
3 GSM w/GPRS
Cell ID
Parameter determines the two byte cell ID in hexadezimal format of the cell that was scanned.
Location Area Code
Parameter determines the two byte location area code in hexadecimal format (e.g. "00C1" equals 193 in deci-
mal) of the cell that was scanned.
Parameter determines the PLMN code of the cell that was scanned.
Parameter determines the ARFCN of the cell that was scanned.
Received signal level of the BCCH carrier. The indicated value is composed of the measured value in dBm plus
an offset. This is in accordance with a formula specified in 3GPP TS 45.008 [39]
Notes
•The AT^SNMON="INS" command is possible even if no SIM is present or no SIM-PIN was entered.
•The AT^SNMON="INS" command depends on the registration state. A complete network scan is only possible
if the module is not registered. To perform a complete scan it is recommended to deregister manually from
the network.
•The AT^SNMON="INS" command may be aborted internally by any other network related activity that inter-
feres with the network scan.
<rb>
(num)
<rat>
(num)
<cid>
(str)
<lac>
(str)
<plmn>
(str)
<arfcn>
(num)
<rssi>
(num)
To Next Page
Loading...
Need help?
General
