BGS2T AT Command Set
9.10 AT+CLIR
BGS2T_ATC_V01.301 Page 230 of 554 1/31/12
c
9.10 AT+CLIR Calling Line Identification Restriction
The AT+CLIR command refers to the supplementary service CLIR (Calling Line Identification Restriction).
Syntax
Parameter Description
Parameter shows the settings for outgoing calls:
[0] Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Note
• The setting of <n> is dependant of the current status at the network. In case of <m>=3 or 4 (temporary mode)
the user settings in the network will be presented.
Test Command
AT+CLIR=?
Response(s)
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR<n>, <m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLIR=[<n>]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
+ + + + + - - 3GPP TS 27.007 [35]
<n>
(num)
<m>
(num)
To Next Page
Loading...
