BGS2T AT Command Set
15.26 AT^SSTR
BGS2T_ATC_V01.301 Page 460 of 554 1/31/12
c
15.26 AT^SSTR SAT Response - Set Up Call (16)
The TE is expected to acknowledge the AT^SSTGI response with AT^SSTR to confirm that the Proactive Com-
mand has been executed.
Syntax
Parameter Description
0...255
0 Command performed successfully. Indicate that the user has accepted the call
request.
4 Command performed successfully, but requested icon could not be displayed.
16 Proactive SIM session terminated by user
20 USSD/SS Transact terminated by user
32 ME currently unable to process command
34 User did not accept the proactive command. Indicate that the user has denied
the call request
35 User cleared down call before connection or network release
48 Command beyond ME's capabilities
132 ME currently unable to process command because screen is busy
Optional additional command status; for possible values refer to 3GPP TS 11.14 [15].
0...255
Note
• After confirmation phase the TE may show a dialling animation on the screen until a mandatory response
parameter is issued.
^SSTR: <cmdType>, <TerminationQualifier>, <TerminationCauseText>
Write Command
AT^SSTR=16, <status>, , [, <statAddInfo>]
Response(s)
^SSTR: 16, <TerminationQualifier>, <TerminationCauseText>
OK
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<status>
(num)
<statAddInfo>
(num)
To Next Page
Loading...
