Gemalto CINTERION BGS2T - 15.16 AT^SSTGI SAT Get Information - Display Text (33)

BGS2T AT Command Set
15.16 AT^SSTGI
BGS2T_ATC_V01.301 Page 444 of 554 1/31/12
c
15.16 AT^SSTGI SAT Get Information - Display Text (33)
This command shall be used after receiving the URC ^SSTN: 33. The TE gets a message to be displayed to the
user. The message can have different display characteristics.
Syntax
Parameter Description
33 Proactive command ID, see Section 15.3, Remote-SAT Command Types and
Table 15.6.
0...255 Used as bit field
bit 1 0: Normal priority (see note).
1: High priority (see note).
bit 2-7 RFU
bit 8 0: Clear message after a delay.
1: Wait for user to clear message.
String to be displayed
This parameter indicates whether the ME should sustain the display beyond sending the TERMINAL
RESPONSE.
0 Send TERMINAL RESPONSE when text is cleared from screen.
1 Send TERMINAL RESPONSE immediately and continue to display the text
until one of the following events occurs:
• A subsequent proactive command is received, containing display data.
• A short delay notified with <commandDetails> has expired.
• User intervention.
Write Command
AT^SSTGI=33
Response(s)
^SSTGI: <cmdType>, <commandDetails>, <text>, <immediateResponse>, <iconQualifier>,
<iconId>
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last
- + + + + - -
<cmdType>
(num)
<commandDetails>
(num)
<text>
(str)
<immediateResponse>
(num)
Confidential / Released