BGS2T AT Command Set
15.16 AT^SSTGI
BGS2T_ATC_V01.301 Page 445 of 554 1/31/12
c
• A higher priority event occurs, e.g. a mobile terminated call.
No further TERMINAL RESPONSE shall be sent when the ME removes the
text from the display, regardless of the cause.
If the <immediateResponse> parameter equals "1" the subsequent "^SSTN:
254" URC should not be used to clear the text from the screen - in this case the
text should remain on the screen until one of the above events occurs.
0...255 Used as bit field
bit 1 0: Icon is self explanatory and replaces text.
1: Icon is not self-explanatory and shall be displayed with the text Determined
value only if associated icon ID is not 0 (an icon exists).
bit 2-8 RFU
0...255
0No Icon
Notes
• The MMI shall reject normal priority text commands if the screen is currently used for more than its normal
standby display, e.g. if the MMI is in sub-menu. If the command is rejected, the MMI sends the TERMINAL
RESPONSE message to the SIM (ME currently unable to process command - screen busy).
• High priority text shall be displayed on the screen immediately, except if a priority conflict of the alerting events
occurs, e.g. incoming call, see 3GPP TS 11.14 [15].
<iconQualifier>
(num)
<iconId>
(num)
To Next Page
Loading...
Need help?
General
