BGS2T AT Command Set
15.34 AT^SSTR
BGS2T_ATC_V01.301 Page 468 of 554 1/31/12
c
15.34 AT^SSTR SAT Response - Get Inkey (34)
The TE is expected to acknowledge the AT^SSTGI response with AT^SSTR to confirm that the Proactive Com-
mand has been executed.
Syntax
Parameter Description
0...255
0 Command performed successfully. Indicate that the user has accepted the call
request.
4 Command performed successfully, but requested icon could not be displayed.
16 Proactive SIM session terminated by user
17 Backward move in the proactive SIM session requested by the user
18 No response from user
19 Help information required by the user
32 ME currently unable to process command
48 Command beyond ME's capabilities
132 ME currently unable to process command because screen is busy
User response entered as a string parameter
Optional additional command status; for possible values refer to 3GPP TS 11.14 [15].
0...255
Notes
• Coding of any input character is related to the selected alphabet:
- Input of a character in case of GSM character set requests one byte, e.g. "Y".
- Input of any characters in UCS2 alphabet requests a 4 byte set, e.g. "0059" is coding the same character
"Y".
- If, as a user response, a binary choice (Yes/No) is requested by the SIM application using bit 3 of the
<commandDetails> parameter the valid content of the <inputString> is:
a) GSM alphabet: "Y" or "y" (positive answer) and "N" or "n" (negative answer).
b) UCS2 alphabet "0079" or "0059" (positive answer) and "006E" or "004E" (negative answer). For more
detailed information refer to AT^SSTGI.
- Coding of an empty string is done as a "\1b" string with every alphabet.
Write Command
AT^SSTR=34, <status>, , <inputString>[, <statAddInfo>]
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<status>
(num)
<inputString>
(str)
<statAddInfo>
(num)
To Next Page
Loading...
Need help?
General
