BGS2T AT Command Set
15.34 AT^SSTR
BGS2T_ATC_V01.301 Page 469 of 554 1/31/12
c
•The <Alphabet> parameter of AT^SSTA determines the alphabet used on the AT command interface, while
the value reported by the <commandDetails> bit 2 of the AT^SSTGI=34 command determines the set of
characters allowed. If these alphabet settings are different, the following applies:
Example: If UCS2 alphabet is selected with AT^SSTA and the <commandDetails> bit 2 of the
AT^SSTGI=34 command is reported as "SMS default alphabet (GSM character set)" any input has to be done
in UCS2 alphabet. However, take care to enter only UCS2 characters for which equivalent characters are
defined in the SMS (GSM) default alphabet. In this case, the ME will correctly translate the given UCS2 data
into a TERMINAL RESPONSE coded in SMS (GSM) default alphabet. See also Section 1.6.2, UCS2 and
GSM character coding and conversion.
To Next Page
Loading...
Need help?
General
