Gemalto CINTERION BGS2T - 13.11 AT+CNMI SMS Event Reporting Configuration

BGS2T AT Command Set
13.11 AT+CNMI
BGS2T_ATC_V01.301 Page 386 of 554 1/31/12
c
13.11 AT+CNMI SMS Event Reporting Configuration
AT+CNMI controls details of the SMS related URC presentation. It selects the procedure how the receipt of a new
SMS from the network is indicated to the TE when TE is active, e.g. DTR signal is ON.
If the TE is inactive (e.g. DTR signal is OFF), message receiving should be done as specified in
3GPP TS 23.038 [27]. If the DTR signal is not available or the state of the signal is ignored (V.250 command
AT&D0, reliable message transfer can be assured by using AT+CNMA acknowledgment procedure.
The rules <mt>=2 and <mt>=3 for storing received messages are possible only if phase 2+ compatibility is acti-
vated with AT+CSMS=1. The parameter <ds>=1 is only available in phase 2+.
Syntax
Unsolicited Result Codes
URC 1
<mt>=1:
+CMTI: <mem3>, <index>
Indicates that new message has been received
URC 2
<mt>=2 (PDU mode enabled):
+CMT: [<alpha>], <length>
<CR><LF><pdu>
Indicates that new message has been received
URC 3
<mt>=2 (text mode enabled):
+CMT: <oa>, [<alpha>], <scts>[, <tooa>, <fo>, <pid>, <dcs>, <sca>, <tosca>,
<length>]
<CR><LF><data>
Indicates that new message has been received
Test Command
AT+CNMI=?
Response(s)
+CNMI: (list of supported<mode>s), (list of supported <mt>s), (list of supported <bm>s), (list of supported
<ds>s), (list of supported <bfr>s)
OK
Read Command
AT+CNMI?
Response(s)
+CNMI: <mode>, <mt>, <bm>, <ds>, <bfr>
OK
Write Command
AT+CNMI=<mode>[, <mt>[, <bm>[, <ds>[, <bfr>]]]]
Response(s)
OK
ERROR
+CMS ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
+ + + + + - - 3GPP TS 27.005 [34]
Confidential / Released