BGS2T AT Command Set
13.1 SMS Parameters
BGS2T_ATC_V01.301 Page 370 of 554 1/31/12
c
Discharge Time
3GPP TS 23.040 [28] TP-Discharge-Time in time-string format: "yy/MM/dd,hh:mm:ss+zz", where characters
indicate year (two last digits), month, day, hour, minutes, seconds and time zone. For example, 6th of May 1994,
22:10:00 GMT+2 hours equals "94/05/06,22:10:00+08"
Integer type; value in the range of location numbers supported by the associated memory
Message Length
Integer type value indicating in the text mode (AT+CMGF=1) the length of the message body <data> (or
<cdata>) in characters; or in PDU mode (AT+CMGF=0), the length of the actual TP data unit in octets (i.e. the
RP layer SMSC address octets are not counted in the length) In text mode, the maximum length of an SMS
depends on the used coding scheme: It is 160 characters if the 7 bit GSM coding scheme is used, and 140 char-
acters according to the 8 bit GSM coding scheme.
If the SMS message format is ''text mode'' (AT+CMGF=1) and the character set is set to ''UCS2'' with AT+CSCS
and the SMS is also coded as "UCS2" (see <dcs> of AT+CSMP), then the length is in octets instead of charac-
ters.
Memory to be used when listing, reading and deleting messages:
“SM“ SIM message storage
“ME“ Mobile Equipment message storage
“MT“
(D)
Sum of "SM" and "ME" storages
Memory to be used when writing and sending messages:
“SM“ SIM message storage
“ME“ Mobile Equipment message storage
“MT“
(D)
Sum of "SM" and "ME" storages
Received messages will be placed in this memory storage if routing to TE is not set. See command AT+CNMI
with parameter <mt>=2.
“SM“ SIM message storage
“MT“
(D)
Sum of "SM" and "ME" storages
Message Identifier
3GPP TS 23.041 [29] CBM Message Identifier in integer format
Message Number
3GPP TS 23.040 [28] TP-Message-Number in integer format
<dt>
(num)
<index>
(num)
<length>
(num)
<mem1>
(str)
<mem2>
(str)
<mem3>
(str)
<mid>
(num)
<mn>
(num)
To Next Page
Loading...
Need help?
General
