BGS2T AT Command Set
2.11 AT+CMEE
BGS2T_ATC_V01.301 Page 48 of 554 1/31/12
c
2.11 AT+CMEE Error Message Format
AT+CMEE controls the format of error result codes that indicates errors related to BGS2T functionality. Format
can be selected between plain "ERROR" output, error numbers or verbose "+CME ERROR: <err>" and "+CMS
ERROR: <err>" messages.
Possible error result codes are listed in Table 2.4, General "CME ERROR" Codes (3GPP TS 27.007), Table 2.5,
General "CME ERROR" Codes (proprietary), Table 2.6, GPRS related "CME ERROR" Codes (3GPP TS 27.007)
and Table 2.7, SMS related "CMS ERROR" Codes (3GPP TS 27.005).
In multiplex mode (refer AT+CMUX) the setting applies only to the logical channel where selected. The setting on
the other channels may differ.
Syntax
Parameter Description
0
(&F)(D)
Disable result code, i.e. only "ERROR" will be displayed.
1 Enable error result code with numeric values.
2 Enable error result code with verbose (string) values.
Example
To
obtain enhanced error messages it is recommended to choose <errMode>=2.
Test Command
AT+CMEE=?
Response(s)
+CMEE: (list of supported<errMode>s)
OK
Read Command
AT+CMEE?
Response(s)
+CMEE: <errMode>
OK
Write Command
AT+CMEE=<errMode>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + + + - - 3GPP TS 27.007 [35], 3GPP TS
27.005 [34]
<errMode>
(num)(&W)(&V)
AT+CMEE=2
OK
To Next Page
Loading...
Need help?
General
