BGS2T AT Command Set
12.6 AT+FCLASS
BGS2T_ATC_V01.301 Page 346 of 554 1/31/12
c
12.6 AT+FCLASS Fax: Select, read or test service class
AT+FCLASS sets the ME to a particular mode of operation (data, fax). This allows the ME to process information
in a manner suitable for that type of information.
Syntax
Parameter Description
0
(&F)
Data (e.g. EIA/TIA-602 or ITU V.250)
1 Fax class 1 (EIA/TIA-578-A, Service Class 1)
2 Fax class 2 (EIA/TIA SP-2388, an early draft version of EIA/TIA-592-A - Ser-
vice class 2.1)
Notes
• Using Error Correcting Mode (ECM) when sending FAXes over GSM should be avoided.
• If <n> is set to 1 or 2, all incoming calls will be answered as fax calls when ATA is issued on multiplexer chan-
nel 1 resp. ASC0. For calls explicitly signaled as voice or data calls, this procedure will fail with result code
"NO CARRIER", but the incoming call will continue to ring.
It is possible to change the setting of <n> to 0 while the call is ringing, and accept the call afterwards with ATA.
Test Command
AT+FCLASS=?
Response(s)
(list of supported <n>s)
OK
Read Command
AT+FCLASS?
Response(s)
<n>
OK
Write Command
AT+FCLASS=<n>
Response(s)
OK
PIN ASC0 MUX1 MUX2 MUX3 Last Reference(s)
- + + - - - - EIA/TIA-592-A
<n>
(num)(&W)(&V)
To Next Page
Loading...
Need help?
General
