BGS2T AT Command Set
10.4 AT^SISS
BGS2T_ATC_V01.301 Page 260 of 554 1/31/12
c
occurred, e.g. network loss, the message will not be deleted on the server even
though the POP3 service command has been finished.
If <srvParmTag> value "pNumber" is zero the "Delete" command deletes all
messages from the POP3 server's maildrop list. In fact, the messages are
marked as deleted on the server and will be deleted permanently if the POP3
service command executes successfully. In case an error has occurred, the
messages will not be deleted on the server even though the POP3 service
command has been finished.
Supported flag values in <srvParmValue> for <srvParmTag> value "pDelFlag". Only applicable if the profile
contains the POP3 user command Retrieve ("3").
[0] Messages will not be deleted on the server.
1 Delete messages on the server which have been retrieved successfully.
Notes
• String parameters are truncated if greater than the maximum length specified above.
• If AT^SISS is used simultaneously on different instances (e.g. Mux channels) only one request can be han-
dled at a time. On the other instance(s) "+CME ERROR: operation temporary not allowed" will be displayed.
If so, repeat the command on this instance.
• For correct input of the @ character in address parameters please refer to Section 1.6, Supported character
sets.
<srvParmValue-pDelFlag>
(num)
To Next Page
Loading...
Need help?
General
