BGS2T AT Command Set
10.4 AT^SISS
BGS2T_ATC_V01.301 Page 258 of 554 1/31/12
c
pLength Maximum message length (string, optional)
Length: 0 ... 2
31
-1
"pLength" can be used to specify the length of the message(s) to be retrieved
from or deleted on the POP3 server. If no specific value is set in the service
profile, the default value "0" is assumed, which means that there is no limit on
the message size.
A warning will be issued inthe following cases:
• If "pNumber" > 0 and a specific message to be retrieved from / deleted on
the server is longer than "pLength".
• If "pNumber" = 0 and all messages to be retrieved from / deleted on the
server are longer than "pLength".
No warning will be issued in the following cases:
• If there are no messages at all on the server.
• If the server has message(s) below and above the "pLength" specified. In
this case, the message(s) within the range of "pLength" can be successfully
retrieved or deleted, but the message(s) above "pLength" remain on the
server without any further notification given to the user.
• Therefore, after retrieving / deleting messages, it is recommended to check
the message status on the server. This can be done by adding a further
POP3 service profile using the POP3 user command List ("2").
pDelFlag Flag to be used with the POP3 user command Retrieve ("3"). Specifies whether
or not to delete retrieved emails on the server (optional).
For supported values of <srvParmValue> refer to <srvParmValue-
pDelFlag>.
tcpMR Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/
MaxRetransmissions" <tcpMr> for a specific Internet Service connection pro-
file. If the parameter is not specified the value specified with AT^SCFG will be
used.
Supported values <srvParmValue> for this parameter are the same as
described for <tcpMr>.
Setting is not relevant for Internet Service "Socket" with type "UDP".
tcpOT Parameter can be used to overwrite the global AT^SCFG parameter "Tcp/Over-
allTimeout" <tcpOt> for a specific Internet Service connection profile. If the
parameter is not specified the value specified with AT^SCFG will be used.
Supported values <srvParmValue> for this parameter are the same as
described for <tcpOt>.
Setting is not relevant for Internet Service "Socket" with type "UDP".
Parameter value; type and supported content depend on related <srvParmTag>.
Supported Internet service type values in <srvParmValue> for <srvParmTag> value "srvType".
Before changing the "srvType" of an existing service profile be sure that the profile is closed. To verify the con-
nection state of the service profile enter the read command AT^SISI. Only when <srvState>=2 is returned
for this specific service profile you can change its service type.
“Socket“ BGS2T acting as client or server (listener) for TCP or UDP.
If BGS2T is TCP listener at least two service profiles are required. The first
socket profile must be configured as
listener. The second s
ervice profile will be
dynamically assigned when a socket connection request from a remote client
is incoming. For this purpose, one service profile must be left free (= not con-
figured with AT^SISS). An incoming socket connection request will be indi-
cated by the "^SIS" URC, with the next free <srvProfileId> shown inside
the URC as parameter <urcInfoId>. The connection request can be
accepted or rejected by using the commands AT^SISO or AT^SISC and the ID
retrieved from the "^SIS".
<srvParmValue>
(str)
<srvParmValue-srvType>
(str)
To Next Page
Loading...
Need help?
General
