BGS2T AT Command Set
3.1 AT+CMER
BGS2T_ATC_V01.301 Page 65 of 554 1/31/12
c
Parameter Description
0
(&F)
Always discard "+CIEV" and "^SLCC" URCs.
1"+CIEV" and "^SLCC" URCs are forwarded directly to the TE. However, if this
is not possible because ME-TE link is reserved, e.g. during a data call, these
URCs are discarded.
2"+CIEV" and "^SLCC" URCs are forwarded directly to the TE. However, if this
is not possible because ME-TE link is reserved these URCs are buffered and
flushed to the TE afterwards. Only one URC of a given type is buffered (previ-
ous one is discarded).
3"+CIEV" and "^SLCC" URCs are forwarded directly to the TE. However, if this
is not possible because ME-TE link is reserved these URCs are buffered and
flushed to the TE afterwards. Only one URC of a given type is buffered (previ-
ous one is discarded).
Additionally, while ME-TE link is reserved, buffered URCs are signaled to the
TE via sending a BREAK or activating the RING line, according to AT^SCFG
parameters <uri>, <udri> and <urat>.
0
(&F)
Keypad event reporting is not supported by BGS2T.
0
(&F)
Display event reporting is not supported by BGS2T.
0
(&F)
Disable indicator event reporting.
2 Enable indicator event reporting.
0
(&F)
ME's buffer of "+CIEV" and "^SLCC" URCs is cleared when <mode> 1, 2 or 3
is entered.
Name of indicator; for a list of all supported indicators please refer to AT+CIND and AT^SIND.
Value of indicator; for a list of all values for the supported indicators please refer to AT+CIND and AT^SIND.
Note
• If ME operates on different instances (Multiplex mode channels 1, 2, 3) avoid different settings for routing and
indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set with
AT+CNMI, AT^SSDA), it is not possible to activate the presentation of URCs with AT+CMER or AT+CNMI on
another instance. Any attempt to activate settings that conflict with existing settings on another interface, will
result in "+CME ERROR", or accordingly "+CMS ERROR".
<mode>
(num)
<keyp>
(num)
<disp>
(num)
<ind>
(num)
<bfr>
(num)
<indDescr>
(str)
<indValue>
(num)
To Next Page
Loading...
Need help?
General
