BGS2T AT Command Set
2.13 AT^SCFG
BGS2T_ATC_V01.301 Page 60 of 554 1/31/12
c
URC mode or polling mode for Internet service commands
This parameter enables or disables the presentation of the following URCs related to Internet service com-
mands: "^SISR" URC, "^SISW" URC and "^SIS" URC for parameter <urcCause>=0 (Internet service events).
"^SIS" URCs with <urcCause>=1 or 2 used to indicate incoming Socket connections are always enabled.
Parameter is global for the ME and non-volatile.
“on“
(D)
Enable URCs related to Internet service commands.
Throughout the Chapter "Internet Service AT Commands" the mode is also
referred to as URC mode.
“off“ Disable URCs related to Internet service commands.
This requires the TE to employ polling techniques when using the Internet ser-
vice AT commands: The TE is responsible to retrieve all status information
needed to control an Internet session. The method is referred to as polling
mode.
CIEV Call Status Indication
This parameter can be used to control the behaviour of URC "+CIEV: call". See also AT+CIND, AT+CMER and
Section 7.1, Call Status Information.
Parameter is global for all interfaces and will not be reset by AT&F.
“restricted“
(P)
URC "+CIEV: call" will be issued only when a Call Status transition ends in
state "active" or "unknown" (see Section 7.1, Call Status Information) for a call
in the list of active calls.
“verbose“ URC "+CIEV: call" will be issued when any state transition (including transi-
tions beginning or ending in state "unknown") occurs in the list of active calls,
or when a traffic channel is established.
SLCC Call Status Indication
This parameter can be used to control the behaviour of URC "^SLCC". See also AT^SLCC and Section 7.1, Call
Status Information.
Parameter is global for all interfaces and will not be reset by AT&F.
“restricted“ URC "^SLCC" will be issued only when a Call Status transition ends in state
"active" or "unknown" (see Section 7.1, Call Status Information) for a call in the
list of active calls
“verbose“
(P)
URC "^SLCC" will be issued when any state transition (including transitions
beginning or ending in state "unknown") occurs in the list of active calls, or
when a traffic channel is established.
URC RING line
This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces
and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator
for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (<groid>).
Parameter is local for the interface, volatile and will not be reset by AT&F.
“off“ URC is not indicated by RING.
“local“
(P)
URC will be indicated by an activated RING line of the interface on which the
URC appears
“asc0“ URC is indicated by an activated RING0 line.
<tcpWithUrc>
(str)(+CSCS)
<succ>
(str)(+CSCS)
<sucs>
(str)(+CSCS)
<uri>
(str)(+CSCS)
To Next Page
Loading...
Need help?
General
