BGS2T AT Command Set
11.2 AT+CGANS
BGS2T_ATC_V01.301 Page 300 of 554 1/31/12
c
using the values for PDP type and address provided by the network. The other parameters will be set to their
default values (see AT+CGDCONT).
If activation is successful, data transfer will proceed.
After data transfer is complete, and the layer 2 protocol termination procedure has completed successfully,
the V.250 command state is reentered and BGS2T returns the final result code OK.
In the event of an erroneous termination or a failure to start up, the V.250 command state is re-entered and
BGS2T returns the final result code NO CARRIER, or if enabled, "+CME ERROR: <err>". Attach, activate and
other errors may be reported. It is also an error to issue the AT+CGANS command when there is no pending
network request.
The command can be used in both normal and modem compatibility modes.
To Next Page
Loading...
