BGS2T AT Command Set
11.11 AT+CGQMIN
BGS2T_ATC_V01.301 Page 322 of 554 1/31/12
c
Notes
• If parameters are not defined, the parameter default values depend on the HLR-stored subscribed default val-
ues.
• Definitions of parameters can be found in 3GPP TS 22.060 [19] and 3GPP TS 23.060 [20] paragraph 15.2
"Quality of Service Profile".
• If some of the QoS parameters are omitted, they will keep their current value (or the default value if not spec-
ified so far).
• If QOS settings are configured with AT+CGQMIN and AT+CGEQMIN in parallel the MT will use only the
AT+CGEQMIN settings for connection setup while the AT+CGQMIN settings are ignored.
To Next Page
Loading...
