BGS2T AT Command Set
19.8 Alphabetical List of AT Commands
BGS2T_ATC_V01.301 Page 554 of 554 1/31/12
c
ATH Manual rejection of a network request for PDP context
activation
Section 11.20, page 334
ATI Display product identification information Section 6.1, page 131
ATO Switch from command mode to data mode / PPP online
mode
Section 7.17, page 156
ATP Select pulse dialing Section 7.29, page 174
ATQ Result Code Presentation Mode Section 2.4, page 38
ATS0 Set number of rings before automatically answering a call Section 7.12, page 151
ATS0 Automatic Response to Network Request for PDP Context
Activation
Section 11.21, page 335
ATS10 Set disconnect delay after indicating the absence of data
carrier
Section 7.16, page 155
ATS18 Extended call release report Section 3.5, page 90
ATS2 Set escape sequence character Section 7.31, page 175
ATS3 Command Line Termination Section 18.2, page 516
ATS4 Response Formatting Section 18.3, page 517
ATS5 Command Line Editing Section 18.4, page 518
ATS6 Set pause before blind dialing Section 7.13, page 152
ATS7 Set number of seconds to wait for connection completion Section 7.14, page 153
ATS8 Comma Dial Pause Time Section 7.15, page 154
ATT Select tone dialing Section 7.30, page 174
ATV Result code format mode Section 2.5, page 39
ATX CONNECT Result Code Format Section 2.6, page 40
ATZ Restore AT Command Settings from User Defined Profile Section 2.7, page 41
AT Command Description Section and Page
To Previous Page
Loading...
