BGS2T AT Command Set
3.3 AT^SIND
BGS2T_ATC_V01.301 Page 74 of 554 1/31/12
c
1 Indicator is registered.
• Indicator event reports are controlled via AT+CMER.
• All indicators can be registered or deregistered via AT^SIND, but different
default settings apply: Power-up and factory default of the indicators sup-
ported by AT+CIND is <mode>=1, while, as stated above, indicators defined
by AT^SIND only are set to <mode>=0.
2 Query the registration status and the current value of a single indicator type.
If delivered by the network: Number of new voice messages sent as part of the Voice Message Waiting Indicator.
Refer to <indDescr>.
Operator in format which depends on the type associated to the operator name. Can be up to 24 characters
long. Refer to <indValue>.
Service Provider Name according to the status settings (SIM Service No. 17) in the SIM Service Table (SST) of
the SIM. Can be up to 16 characters long.
Universal Time delivered as part of the "nitz" Indicator. Refer to <indDescr>.
Time Zone delivered as part of the "nitz" Indicator. Refer to <indDescr>.
Adjustment for Daylight Saving Time as part of the "nitz" Indicator. Refer to <indDescr>.
Example
Activa
tion and use of indicator "audio":
<vmCounter>
<eonsOperator>
(+CSCS)
<servProvider>
(str)(+CSCS)
<nitzUT>
<nitzTZ>
<nitzDST>
AT^SIND="audio",1
You register the indicator "audio".
^SIND: audio,1,0
OK
AT+CMER=2,,,2
You activate the Indicator Event Report with AT+CMER.
OK
A set of all registered URCs is presented. (Please note that the example
includes the indicators registered due to the power-up default settings
of AT+CIND.)
+CIEV: battchg,5
+CIEV: signal,0
+CIEV: service,1
+CIEV: sounder,0
+CIEV: message,1
+CIEV: call,0
+CIEV: roam,0
+CIEV: smsfull,0
+CIEV: rssi,4
+CIEV: audio,0
ATD030123456;
You make a call.
OK
+CIEV: audio,1
To Next Page
Loading...
Need help?
General
