Operation Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 BGP Configuration
Huawei Technologies Proprietary
5-9
Table 5-11 Configuring itself as the next hop in advertising route
Operation Command
Configure itself as the next hop in advertising
route
peer { peer-address | group-name }
next-hop-local
Disable the specification of itself as the next
hop in advertising route
undo peer { peer-address |
group-name } next-hop-local
By default, local router does not specify itself as the next hop while advertising route to
a peer (group).
V. Removing private AS numbers while transmitting BGP update messages
Generally, the AS numbers (public AS numbers or private AS numbers) are included in
the AS paths while transmitting BGP update messages. This command is used to
configure certain outbound routers to ignore the private AS numbers while transmitting
update messages.
Table 5-12 Removing private AS numbers while transmitting BGP update messages
Operation Command
Remove private AS numbers while
transmitting BGP update messages
peer { peer-address | group-name }
public-as-only
Include private AS numbers while
transmitting BGP update messages
undo peer { peer-address |
group-name } public-as-only
By default, the private AS numbers are included while transmitting BGP update
messages.
VI. Configuring to send the community attributes to a peer or peer group
Table 5-13 Configuring to send the community attributes to a peer or peer group
Operation Command
Configure to send the community
attributes to a peer or peer group
peer { group-name | peer-address }
advertise-community
Configure not to send the community
attributes to a peer or peer group
undo peer { group-name |
peer-address } advertise-community
VII. Configuring the repeating time of local AS
Using peer allow-as-loop command, the repeating time of local AS can be configured.
Perform the following configurations in BGP view.
To Next Page
Loading...
Need help?
General
