user@host> show chassis routing-engine
user@host> show chassis routing-engine
Routing Engine status:
Temperature 22 degrees C / 71 degrees F
DRAM 768 Mbytes
CPU utilization:
User 0 percent
Background 0 percent
Kernel 0 percent
Interrupt 0 percent
Idle 100 percent
Model teknor
Serial ID 4d0000062b049501
Start time 2002-04-29 11:18:31 PDT
Uptime 5 hours, 20 minutes, 17 seconds
Load averages: 1 minute 5 minute 15 minute
0.06 0.03 0.00
Meaning The command output displays the Routing Engine slot number, current state (Master,
Backup, or Disabled), election priority (Master or Backup), and the airflow temperature.
The command output also displays the total DRAM available to the Routing Engine
processor, the CPU utilization percentage, and the Routing Engine serial number for the
slot. Additionally, the command output displays when the Routing Engine started running,
how long the Routing Engine has been running, and the time, uptime, and load averages
for the last 1, 5, and 15 minutes.
Check the Uptime to ensure that the Routing Engine has not rebooted since it started
running.
Related
Documentation
Checklist for Monitoring the Routing Engine on page 165•
• Host Module Overview on page 435
Check the MCS Status
Purpose This section provides a brief description of monitoring the MCS as part of the host module
on M40e and M160 routers.
Action To monitor the MCS status, use the following command:
user@host> show chassis environment mcs
user@host> show chassis environment mcs
MCS 0 status:
State Online Master
Temperature 43 degrees C / 109 degrees F
Power:
3.3 V 3318 mV
5.0 V 4974 mV
12.0 V 11824 mV
5.0 V bias 4974 mV
8.0 V bias 8212 mV
BUS Revision 12
FPGA Revision 13
MCS 1 status:
439Copyright © 2012, Juniper Networks, Inc.
Chapter 17: Monitoring the Host Module
To Next Page
Loading...
Need help?
General
