Juniper M Series - Page 690

scc-re0:
--------------------------------------------------------------------------
Class Item Status Measurement
Fans Top Left Front fan OK Spinning at normal speed
Top Left Middle fan OK Spinning at normal speed
Top Left Rear fan OK Spinning at normal speed
Top Right Front fan OK Spinning at normal speed
Top Right Middle fan OK Spinning at normal speed
Top Right Rear fan OK Spinning at normal speed
Bottom Left Front fan OK Spinning at normal speed
Bottom Left Middle fan OK Spinning at normal speed
Bottom Left Rear fan OK Spinning at normal speed
Bottom Right Front fan OK Spinning at normal speed
Bottom Right Middle fan OK Spinning at normal speed
Bottom Right Rear fan OK Spinning at normal speed
Rear Tray Top fan OK Spinning at normal speed
Rear Tray Second fan OK Spinning at normal speed
Rear Tray Third fan OK Spinning at normal speed
Rear Tray Fourth fan OK Spinning at normal speed
Rear Tray Fifth fan OK Spinning at normal speed
Rear Tray Sixth fan OK Spinning at normal speed
Rear Tray Seventh fan OK Spinning at normal speed
Rear Tray Bottom fan OK Spinning at normal speed
For TX Matrix Plus routers (see also “TX Matrix Plus Router Redundant Cooling System
Components” on page 642)
user@host> show chassis environment sfc 0
sfc0-re0:
--------------------------------------------------------------------------
Class Item Status Measurement
Fans Fan Tray 0 Fan 1 OK Spinning at normal speed
Fan Tray 0 Fan 2 OK Spinning at normal speed
Fan Tray 0 Fan 3 OK Spinning at normal speed
Fan Tray 0 Fan 4 OK Spinning at normal speed
Fan Tray 0 Fan 5 OK Spinning at normal speed
Fan Tray 0 Fan 6 OK Spinning at normal speed
Fan Tray 1 Fan 1 OK Spinning at normal speed
Fan Tray 1 Fan 2 OK Spinning at normal speed
Fan Tray 1 Fan 3 OK Spinning at normal speed
Fan Tray 1 Fan 4 OK Spinning at normal speed
Fan Tray 1 Fan 5 OK Spinning at normal speed
Fan Tray 1 Fan 6 OK Spinning at normal speed
Fan Tray 2 Fan 1 OK Spinning at normal speed
Fan Tray 2 Fan 2 OK Spinning at normal speed
Fan Tray 2 Fan 3 OK Spinning at normal speed
Fan Tray 2 Fan 4 OK Spinning at normal speed
Fan Tray 2 Fan 5 OK Spinning at normal speed
Fan Tray 2 Fan 6 OK Spinning at normal speed
Fan Tray 2 Fan 7 OK Spinning at normal speed
Fan Tray 2 Fan 8 OK Spinning at normal speed
Fan Tray 2 Fan 9 OK Spinning at normal speed
Fan Tray 3 Fan 1 OK Spinning at normal speed
Fan Tray 3 Fan 2 OK Spinning at normal speed
Fan Tray 3 Fan 3 OK Spinning at normal speed
Fan Tray 3 Fan 4 OK Spinning at normal speed
Fan Tray 3 Fan 5 OK Spinning at normal speed
Fan Tray 3 Fan 6 OK Spinning at normal speed
Fan Tray 3 Fan 7 OK Spinning at normal speed
Fan Tray 3 Fan 8 OK Spinning at normal speed
Fan Tray 3 Fan 9 OK Spinning at normal speed
Copyright © 2012, Juniper Networks, Inc.646
M Series and T Series Routers Monitoring and Troubleshooting Guide