EasyManuals Logo

Keyence SV Series User Manual

Default Icon
318 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
2-7
- SV Series User’s Manual -
CONFIGURATION & SPECIFICATIONS
2
2-3 Servo Amplifier Specifications
This section describes the specifications of the SV series servo amplifier.
General Specifications
Item Specifications
Model
200 V type SV-0052 SV-0102 SV-0202SV-0402 SV-0752
100 V type SV-0051 SV-0101 SV-0201SV-0401-
Capacity 50 W 100 W 200 W 400 W 750 W
Input power supply
Voltage/
frequency
Main
circuit
200 V type
3-phase or single-phase, 200 to 230 VAC, 50/60 Hz 270 to 320 VDC
100 V type
Single-phase, 100 to 115 VAC, 50/60 Hz
Control
circuit
200 V type
Single-phase, 200 to 230 VAC, 50/60 Hz 270 to 320 VDC
100 V type
Single-phase, 100 to 115 VAC, 50/60 Hz
Allowable
voltage
fluctuation
Main
circuit/
Control
circuit
200 V type
170 to 253 VAC
100 V type
85 to 127 VAC
Allowable
frequency
fluctuation
Main circuit/
Control circuit
±5% max.
Allowable
momentary
power failure
Main circuit Full (100% down): 0.5 cycle, Partial (50% down): 1 cycle
Control circuit Approx. 100 ms (200 V), Approx.65ms (100 V)
Overvoltage category III
Control system
3-phase full-wave rectification, IGBT PWM control, sinusoidal current
drive system
Feedback 20-bit serial encoder (incremental/absolute) transmission
Environment
Surrounding Air temperature 0 to +55°C (No freezing)
Storage ambient temperature
-
20 to +70°C(No freezing)
Operating/storage ambient humidity 90% RH max. (No condensation)
Resistance to vibration 4.9 m/s
2
(Complies to JIS C60068-2-6)
Shock resistance 19.6 m/s
2
(Complies to JIS C60068-2-27)
Operating atmosphere
(Enclosure rating, Pollution degree)
Pollution degree: 2 (Inside the industrial control panel with IP54 or higher)
- No corrosive or flammable gas.
- Do not splash water, oil, or chemicals onto the unit.
- No dust in the operation area.
Altitude 1,000 m max. above sea level
Applicable
standards
UL/CSA Standard UL508C, CSA C22.2 No.14
CE Marking
Low-voltage Directive
EN50178
EMI EN55011 Class A, EN61800-3
EMS EN61800-3, EN61000-6-2
North American EMI Regulation FCC Part15 B, ICES-003. Class A
Structure
Installation Base mount
Protection Open, forced cooling
Minimum insulation resistance 1 MΩ min. with 500 VDC megohmmeter
Insulation withstand voltage
1500 VAC min. (between primary side and ground)
1800 VAC min. (between primary side and secondary side)
Weight
Model SV-0052 SV-0102 SV-0202SV-0402 SV-0752
Weight Approx. 0.9kg Approx. 1kg Approx. 1.5kg
Model SV-0051 SV-0101 SV-0201SV-0401-
Weight Approx. 1.1kg Approx. 1.5kg

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keyence SV Series and is the answer not in the manual?

Keyence SV Series Specifications

General IconGeneral
DisplayLCD
Output TypeDigital, Analog
Power Supply24V DC
CommunicationEthernet, RS-232, RS-485
SeriesSV Series
Programming LanguageLadder Logic
MountingPanel mounting
Operating Temperature0 to +50°C
Storage Temperature-20 to +60°C
Vibration Resistance10 to 55 Hz
Shock Resistance30G