2-44 Options Service Manual
4024-XXX
243.04 Sensor (tray 3 feed-out) static jam
7 Check the sensor (registration) for proper connection.
Is the above sensor connected properly?
Replace the sensor
(registration).
Refer to the Printer
Service Manual.
Replace the
connection.
8 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter Diagnostics mode.
2. Select INPUT TRAY TESTS.
3. Select Sensor Tests.
4. Select Tray 3.
5. Select Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Go to step 10. Go to step 9.
9 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
Replace the sensor
(tray 3 feed-out).
Go to “2000-sheet
dual input (TTM)—
sensor (tray 3 feed-
out) removal” on
page 4-89.
Replace the
connection.
10 Check the connection between the 2TM/TTM controller
card assembly and the printer engine card assembly.
Are the above boards connected properly?
Go to step 11. Replace the
connection.
11 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2000-sheet
dual input (TTM)—
2TM/TTM controller
card assembly
removal” on
page 4-116.
Go to step 12.
Problem solved.
12 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Refer to the Printer
Service Manual.
Problem solved.
Step Check Yes No
1 Check the media position.
Does the media touch the sensor (tray 3 feed-out)?
Open the 2TM/TTM left door assembly, and visually
check it.
Remove the media. Go to step 2.
Step Check Yes No
To Next Page
Loading...
