Repair information 4-207
4024-XXX
Exit 2 sensor (exit 2 media shift HP) removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-192.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-197.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-198.
5. Remove the exit 2 media shift gear. See “Exit 2 right cover removal” on page 4-198.
6. Rotate the shift assembly (A) upward in the direction of the arrow.
7. Disconnect the connector from the sensor (exit 2 media shift HP) (B).
8. Release the hooks securing the sensor (exit 2 media shift HP) (B) to the exit 2 unit assembly.
9. Remove the sensor (exit 2 media shift HP) (B).
LOW CHUTE
B
Connector
Hooks
A
Rear
To Next Page
Loading...
