4-40 Options Service Manual
4024-XXX
2X 500-sheet drawer (2TM)—lower media transport roll assembly removal
1. Open the 2TM/TTM left door assembly.
2. Remove the two screws securing the lower bracket (A).
3. Disconnect the connector from the lower bracket (A).
4. Remove the large e-clip securing the 2TM/TTM media transport roll assembly (B).
5. Remove the bearing (C).
6. Move the 2TM/TTM media transport roll assembly (B) to the right and outward in the direction of the arrow
to remove.
7. Remove the 2TM/TTM media transport roll assembly (B).
Note: One of the bearings may become detached.
8. Remove the two e-clips with a prying tool on the 2TM/TTM media transport roll assembly (B), the gear (D),
and the bearing (C).
Note: When removing the 2TM/TTM media transport roll assembly (B), do not touch the rubber surface.
Note: Before re-installing the 2TM/TTM media transport roll assembly (B), do not touch the rubber surface.
Connector
A
D
E-ring
E-clip
C
B
Left
E-ring
C
To Next Page
Loading...
