3-14 Options Service Manual
4024-XXX
• Punch and Staple
Punch side reg1
Punch side reg2
Punch box set
Punch waste full
Low staple
Punch carriage shift hp
Punch unit hp
Stapler carriage shift hp
Punch cam front
Punch hole select
Press Back () or Stop ( ) to exit the test.
BASE SENSOR TEST
This test is used to determine if the sensors located inside the printer are working correctly.
To run the Base Sensor Test:
1. Select BASE SENSOR TEST from DIAGNOSTICS.
2. Select one of the test categories:
• Cover and Door
• Devices
• Exit level
• Media Path
3. Select the actual test to perform.
Each of the tests categories includes the individual sensors that can be manually actuated, and the display
shows Open or Closed.
• Cover and Door
Door A left side
Door B left/lower
Door C 2tm/ttm
Door D duplex left
Door E exit2 left
Door J front
Door K hcf top
• Devices
PC unit present
Exit2 present
• Exit level
Std bin full exit1
Std bin full exit2
• Media Path
Registration
Fuser exit
Exit1 shift hp
Exit2
Exit2 shift hp
Manually actuate the sensors to verify that each sensor switches from Open to Closed.
Press Back () or Stop ( ) to exit the test.
To Next Page
Loading...
