2-12 Options Service Manual
4024-XXX
243.04 Sensor (tray 3 feed-out) static jam
11 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2X 500-
sheet drawer
(2TM)—2TM/TTM
controller card
assembly removal”
on page 4-43.
Go to step 12.
Problem solved.
12 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Refer to the Printer
Service Manual.
Problem solved.
Step Check Yes No
1 Check the media position.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the media touch the tray 3 feed-out sensor?
Remove the media. Go to step 2.
2 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter Diagnostics mode.
2. Select INPUT TRAY TESTS.
3. Select Sensor Tests.
4. Select Tray 3.
5. Select Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator for the above sensor operates?
Go to step 4. Go to step 3.
3 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
Replace the sensor
(tray 3 feed-out).
Go to “2X 500-
sheet drawer
(2TM)—sensor
(tray 3 feed-out)
removal” on
page 4-37.
Replace the
connection.
4 Perform a print test.
Does the error still occur?
Replace the 2TM/
TTM controller card
assembly.
Go to “2X 500-
sheet drawer
(2TM)—2TM/TTM
controller card
assembly removal”
on page 4-43.
Go to step 5.
Problem solved.
Step Check Yes No
To Next Page
Loading...
