Lexmark W840 - 500-Sheet Drawer (2 TM)-Transport Clutch Removal

4-44 Options Service Manual
4024-XXX
2X 500-sheet drawer (2TM)—transport clutch removal
1. Remove the rear cover. See “2X 500-sheet drawer (2TM)—rear cover removal” on page 4-5.
2. Disconnect the connector from the machine to the bracket (A).
3. Remove the two screws securing the bracket (A) to the frame assembly.
4. Remove the bracket (A).
Note: The bushing (B) and washer (C) may become detached from the shaft (D).
5. Remove the e-clip using a prying tool securing the clutch gear 38 tooth (E) to the shaft (D), and remove the
clutch gear - 38 tooth (E).
6. Disconnect the connector of the transport clutch (F) from the bracket (A).
7. Remove the transport clutch (F).
Note: Before re-installing, ensure the notch on the transport clutch (F) is placed over the boss of the bracket
(A). Ensure the harness does not contact the gears.
A
Rear
B
C
B
A
E
E-ring
Rear
F
D