Lexmark W840 - HCF Pick Roll Shaft Assembly Removal

Repair information 4-141
4024-XXX
HCF pick roll shaft assembly removal
1. Open the HCF top door.
2. Open the HCF feed unit assembly.
3. Remove the HCF pick roll assembly. See “HCF pick roll assembly removal” on page 4-142.
4. Remove the e-clip with a prying tool securing the HCF pick roll shaft assembly (A) to the HCF media feed
unit assembly (B).
5. Remove the bushing (C) from the HCF media feed unit assembly (B).
6. Remove the bearing (D) from the HCF media feed unit assembly (B).
7. Remove the HCF pick roll shaft assembly (A).
B
D
C
E-ring
A
Front