2-100 Options Service Manual
4024-XXX
919.01 Exit 2 unit assembly connection failure
3 Check the media shift motor for proper operation.
1. Enter Diagnostics mode.
2. Select MOTOR TESTS.
3. Select Exit2 shift mtr.
Does the above motor rotate properly?
Go to step 5. Go to step 4.
4 Check the media shift motor for proper connection.
Is the above motor connected properly?
Replace the media
shift motor.
Go to “Exit 2 unit
assembly removal”
on page 4-192.
Replace the
connection.
5 Perform a print test.
Does the error still occur?
Replace the exit
interface card
assembly.
Refer to the Printer
Service Manual.
Go to step 6.
Problem solved.
6 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Refer to the Printer
Service Manual.
Problem solved.
Step Check Yes No
1 Check the exit 2 unit assembly for proper installation.
Is the exit 2 unit assembly installed properly?
Go to step 2. Reinstall the exit 2
unit assembly, and
POR.
Go to Go to “Exit 2
unit assembly
removal” on
page 4-192.
2 Check the exit 2 unit assembly connector.
Is the exit 2 unit assembly connector or the connector
attached to the printer damaged?
Replace the exit 2
unit assembly or
damaged connector.
Go to Go to “Exit 2
unit assembly
removal” on
page 4-192.
Go to step 3.
3 Perform a print test.
Does the error still occur?
Replace the exit
interface card
assembly.
Refer to the Printer
Service Manual.
Go to step 4.
Problem solved.
4 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Refer to the Printer
Service Manual.
Problem solved.
Step Check Yes No
To Next Page
Loading...
