Repair information 4-149
4024-XXX
HCF media transport roll assembly removal
1. Remove the HCF unit from the printer.
2. Remove the HCF right cover. See “HCF right cover removal” on page 4-120.
3. Remove the e-clip with needle nose pliers on the front side securing the HCF media transport roll
assembly (A) to the unit.
4. Move the HCF transport shaft assembly (A) toward the rear in the direction of the arrow to remove it from
the bearing (B).
Note: The bearing (B) may become detached.
Note: When removing the HCF media transport roll assembly (A), do not touch the rubber surface.
Note: Before re-installing the HCF media transport roll assembly (A), do not touch the rubber surface.
To Next Page
Loading...
