Lexmark W840 - 500-Sheet Drawer (2 TM)-Media Feed Unit Assembly Removal (Tray 4)

Repair information 4-11
4024-XXX
2X 500-sheet drawer (2TM)—media feed unit assembly removal (tray 4)
1. Remove tray 4.
2. Open the 2TM/TTM left door assembly (A).
3. Remove one screw securing the 2TM/TTM left door support strap (B).
4. Remove the plastic bosses on both ends of the vertical turn guide (C).
5. Remove the vertical turn guide (C).
6. Release the harness from the clamp.
7. Disconnect the connector from the machine.
8. Remove the two screws securing the media feed unit assembly (D).
9. Remove the media feed unit assembly (D) in the direction of the arrow.
D
Boss
C
A
Boss
Left
B
Harness
Connector
Clamp
D
A
Left