2-94 Options Service Manual
4024-XXX
203.01 Sensor (exit 2) off jam
9 Check the sensor (exit 2) for proper operation.
Open the printer left door assembly and the exit 2 left
door assembly.
1. Enter Diagnostics mode.
2. Select BASE SENSOR TESTS.
3. Select Media Path.
4. Select Exit2.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Go to step 11. Go to step 10.
10 Check the sensor (exit 2) for proper connection.
Is the above sensor connected properly?
Replace the sensor
(exit 2).
Go to “Exit 2
sensor (exit 2)
removal” on
page 4-206.
Replace the
connection.
11 Check the media diverter solenoid for proper operation.
1. Enter Diagnostics mode.
2. Select MOTOR TESTS.
3. Select Diverter solenoid.
Does the above component operate normally?
Go to step 13. Go to step 12.
12 Check the media diverter solenoid for proper
connection.
Is the above component connect properly?
Replace the media
diverter solenoid.
Go to “Exit 2 media
diverter solenoid
removal” on
page 4-205.
Replace the
connection.
13 Perform a print test.
Does the error still occur?
Replace the exit
interface card
assembly.
Refer to the Printer
Service Manual.
Go to step 14.
Problem solved.
14 Perform a print test.
Does the error still occur?
Replace the printer
engine card
assembly.
Refer to the Printer
Service Manual.
Problem solved.
Step Check Yes No
1 Check the media position.
Open the exit 2 left door assembly, and visually check it.
Does the media touch the sensor (exit 2)?
Remove the media. Go to step 2.
Step Check Yes No
To Next Page
Loading...
