Lexmark W840 - Error Code Messages - EX2

2-92 Options Service Manual
4024-XXX
Error code messages - EX2
Error code or
message
Error Contents Description/Action
203.00
Paper jam
Check area A
Sensor (exit 2) on jam The sensor (exit 2) is not turned on within the specified
time after the sensor (fuser exit) is turned on.
Go to “203.00 Sensor (exit 2) on jam” on page 2-93.
203.01
Paper jam
Check areas A,
E
Sensor (exit 2) off jam The sensor (exit 2) is not turned off within the specified
time after the sensor (exit 2) is turned on.
Go to “203.01 Sensor (exit 2) off jam” on page 2-94.
203.02
Paper jam
Check area A
Sensor (exit 2) on jam in
standard bin or simplex finisher
The sensor (exit 2) was turned on when the media is
delivered to the exit 1 standard bin or simplex finisher.
Go to “203.02 Sensor (exit 2) on jam in standard bin
or finisher” on page 2-96.
203.03
Paper jam
Check areas A,
E
Sensor (exit 2) static jam Media remains on the sensor (exit 2).
Go to “203.03 Sensor (exit 2) static jam” on
page 2-97.
230.00
Paper jam
Check areas A,
E
Sensor (duplex wait) on jam The sensor (duplex wait) is not turned on within the
specified time after the exit 2 drive motor is turned on.
Go to “230.00 Sensor (duplex wait) on jam” on
page 2-98.
919.00
Service std
bin 2
Sensor (exit 2 media shift HP)
failure
The sensor (exit 2 media shift HP) is not turned on within
the specified time after the media shift motor is turned
on.
Go to “919.00 Sensor (exit 2 media shift HP) failure”
on page 2-99.
919.01
Service std
bin 2
Exit 2 unit assembly
connection failure
Exit 2 unit assembly connection is missing or damaged.
Go to “919.01 Exit 2 unit assembly connection
failure” on page 2-100.
Close door E Exit 2 left door assembly open The exit 2 left door is open.
Go to “Exit 2 left door assembly open” on
page 2-101.