Lexmark W840 - Exit 2 Actuator Removal

Repair information 4-201
4024-XXX
Exit 2 actuator removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-192.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-197.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-198.
5. Release the spring (A) on the exit 2 actuator (B).
6. Move the exit 2 actuator (B) to the right in the direction of the arrow to release two hooks.
7. Remove the exit 2 actuator (B).
8. Remove the spring (A) from the exit 2 actuator (B).
Note: Before reinstalling the exit 2 actuator (B), ensure the spring (A) is properly installed.
B
B
A
A
Front