Lexmark W840 - 2000-Sheet Dual Input (TTM)-Tray 3 Lift Gear Assembly Removal

Repair information 4-113
4024-XXX
2000-sheet dual input (TTM)—tray 3 lift gear assembly removal
1. Remove the rear cover. See “2000-sheet dual input (TTM)—rear cover removal” on page 4-51.
2. Remove the media feed unit 3 assembly. See “2000-sheet dual input (TTM)—media feed unit
assembly removal (tray 3)” on page 4-85.
3. Release the harness from the clamp of the tray 3 lift gear assembly (A).
4. Remove two screws securing the tray 3 lift gear assembly (A).
5. Remove the tray 3 lift gear assembly (A).
Clamp
Clamp
A