Lexmark W840 - 500-Sheet Drawer (2 TM)-2 TM;TTM Controller Card Assembly Removal

Repair information 4-43
4024-XXX
2X 500-sheet drawer (2TM)—2TM/TTM controller card assembly removal
1. Remove the rear cover. See “2X 500-sheet drawer (2TM)—rear cover removal” on page 4-5.
2. Disconnect all the connectors from the 2TM/TTM controller card assembly (A).
3. Remove the four screws securing the 2TM/TTM controller card assembly (A).
4. Remove the 2TM/TTM controller card assembly (A).
A
Rear
P541
P548
P554
P552
P649
2TM/TTM control card
DIP
switch
On
1
23
4
DIP switch settings, 2TM