4-206 Options Service Manual
4024-XXX
Exit 2 sensor (exit 2) removal
1. Remove the exit 2 unit assembly. See “Exit 2 unit assembly removal” on page 4-192.
2. Open the exit 2 unit assembly.
3. Remove the exit 2 left cover. See “Exit 2 left cover removal” on page 4-197.
4. Remove the exit 2 right cover. See “Exit 2 right cover removal” on page 4-198.
5. Disconnect the connector from the sensor (exit 2) (A).
6. Pull the exit 2 sensor (actuator) (B) back in the direction of the arrow.
7. Release the hooks securing the sensor (exit 2) (A) to the exit 2 unit assembly.
8. Remove the sensor (exit 2) (A).
To Next Page
Loading...
