Diagnostic aids 3-5
4024-XXX
MOTOR TESTS
The tests in this group allow you to test specific motors, and on some motors run them forward or reverse.
To run the MOTOR TESTS:
1. Select MOTOR TESTS from DIAGNOSTICS.
2. Select the test to run. The following tests are available:
Once selected the name of the selected test appears on the operator panel.
3. If available, Forward and Reverse appear for selected tests.
To stop the test, press Back () or Stop ().
PRINT TESTS
Input source tests
The purpose of the diagnostic Print Tests is to verify that the printer can print on media from each of the installed
input options. The content of the Print Test Page varies depending on the media installed in the selected input
source.
Check each Test Page from each source to assist in print quality and paper feed problems.
To run the Print Test Page:
1. Select PRINT TESTS from DIAGNOSTICS.
2. Select the media source.
Tray 1
Tray 2
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multipurpose Feeder
3. Select Single or Continuous.
• If Single is selected, a single page is printed.
• If Continuous is selected, printing continues until Stop ( ) is pressed to cancel the test.
If a source is selected that contains envelopes, an envelope test pattern is printed. If Continuous is
selected, the test pattern is printed only on the first envelope.
Note: The Print Test Page always prints on one side of the paper, regardless of the duplex setting or the
presence of a duplex option.
Press Back ( ) to return to PRINT TESTS.
• Transport mtr • MPF pick solenoid
• Fuser cooling fan • Transport clutch
• PC unit cooling fan • Duplex drv mtr
• Toner add mtr • Diverter solenoid
• Drum unit mtr • Exit2 cooling fan
• Registrat clutch • Exit1 shift mtr
• Tray 1 feed mtr • Exit2 shift mtr
• Tray 2 feed mtr • Exit2 drive mtr
• Tray 3 feed mtr
• Tray 4 feed mtr
• Tray 5 feed mtr
To Next Page
Loading...
