Lexmark W840 - 2000-Sheet Dual Input (TTM)-Lift Coupling Assembly Removal

Repair information 4-91
4024-XXX
2000-sheet dual input (TTM)—lift coupling assembly removal
1. Remove the media feed unit assembly. See “2000-sheet dual input (TTM)—media feed unit assembly
removal (tray 3)” on page 4-85 or “2000-sheet dual input (TTM)—media feed unit assembly removal
(tray 4)” on page 4-80.
2. Remove the harness from bracket (A).
3. Remove three screws securing bracket (A) to the media feed unit assembly.
4. Remove bracket (A).
Note: The gears may become detached from bracket (A).
5. Remove the e-ring with a prying tool securing the tray lift coupling (B) to bracket (A).
6. Remove the tray lift coupling gear 31 tooth (C).
7. Remove the spring (D).
Note: Before re-installing, ensure all gears and washers attached to bracket (A) are securely installed.
Clamp
A
Rear
E-ring
Washer
D
C
B