Lexmark W840 - Page 161

Diagnostic aids 3-3
4024-XXX
HARDWARE TESTS
Panel Test See “Panel Test” on page 3-6
Button Test See “Button Test” on page 3-6
DRAM Test See “DRAM Test” on page 3-7
CACHE Test
Parallel Wrap See “Parallel Wrap tests” on page 3-8
Parallel 1 Wrap (if installed)
Parallel 2 Wrap (if installed)
Serial 1 Wrap (if installed) See “Serial Wrap tests” on page 3-8
Serial 2 Wrap (if installed)
DUPLEX TESTS (if installed)
Quick Test See “Quick Test (duplex)” on page 3-9
Sensor Test See “Sensor Test (duplex)” on page 3-9
INPUT TRAY TESTS
Feed Tests See “Feed Tests (input tray)” on page 3-10
Sensor Test See “Sensor Test (input tray)” on page 3-10
OUTPUT BIN TESTS
Feed Tests See “Feed Tests (output bins)” on page 3-11
Feed To All Bins See “Feed To All Bins” on page 3-11
Sensor Test See “Sensor Test (output bin)” on page 3-11
FINISHER TESTS (if installed)
Staple Test See “Staple Test” on page 3-12
Feed Tests See “Feed Tests” on page 3-12
Sensor Test See “Sensor Test (finisher)” on page 3-13
BASE SENSOR TEST See “BASE SENSOR TEST” on page 3-14
Toner
Input
Output
DEVICE TESTS
Quick Disk Test (if installed) See “Quick Disk Test” on page 3-15
Disk Test/Clean (if installed) See “Disk Test/Clean” on page 3-15
Flash Test (if installed) See “Flash Test” on page 3-16
PRINTER SETUP
Defaults See “Defaults” on page 3-16
Page Count See “Page Count” on page 3-16
Perm Page Count See “Perm Page Count (permanent page count)” on page 3-16
Serial Number See “Serial Number” on page 3-17
Engine Setting 1 through 4 See “Engine Setting 1 through 4” on page 3-17
Model Name See “Model Name” on page 3-17
Configuration ID See “Configuration ID” on page 3-17
Edge to Edge See “Edge to Edge” on page 3-17
Diagnostics mode tests (continued)