4-72 Options Service Manual
4024-XXX
10. Remove two E-clips with a prying tool securing the two small pulleys (F) on the rear of the frame assembly.
11. Remove two small guides (G) and two small pulleys (F).
12. Remove the tray 4 rear cables (D) from the bottom plate (H).
Note: Before re-installing:
– It is recommended that all four cables be replaced.
– Ensure tray 4 rear cables (D) are not twisted or kinked.
– Route the cables properly as shown in the figure.
– Replace the cables by setting the frame assembly on its side as shown in the figure.
To Next Page
Loading...
