4-74 Options Service Manual
4024-XXX
7. Place the tray 4 assembly back in its upright position.
8. Remove two E-clips with a prying tool securing the two small pulleys (D) on the front of the frame
assembly.
9. Remove the two small guides (E) and the two small pulleys (D).
10. Remove the tray 4 front cables (C) from the bottom plates (F).
Note: Before re-installing:
– It is recommended that all four cables be replaced.
– Ensure tray 4 front cables (C) are not twisted or kinked.
– Route the cables properly as shown in the figure.
– Replace the cables by setting the frame assembly (B) on its side as shown in the figure.
To Next Page
Loading...
