Lexmark W840 - Page 392

4-180 Options Service Manual
4024-XXX
8. Disconnect the connector of the harness from duplex motor assembly (D) to the duplex main cable
assembly.
9. Release the harness from the clamps of the duplex unit assembly.
10. Remove the two screws securing the duplex drive motor assembly (E) to the duplex unit assembly.
11. Remove the duplex drive motor assembly (E).
12. Remove the duplex drive motor duct (F) from the duplex drive motor assembly (E).
13. Remove the e-clip with a prying tool securing the duplex drive motor fan (G) to the duplex drive motor
assembly (E).
14. Remove the duplex drive motor fan (G).
Clamps
D
G
E-Ring
Connector
Mark
Screws
F
E
Left