Oki IP-6620 - Page 100

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 3 Maintenance Mode Functions and Operations
3-60
(b) FEED MEDIA and BACK FEED MEDIA
In the EDGE SENSOR ADJUST menu, select FEED MEDIA or BACK FEED MEDIA with the Up
and Down buttons.
Hold the OK button pressed to feed or backfeed the media.
Release the OK button to stop feeding or backfeeding and to return to the previous screen.
(c) SENSOR ADJ VAL
Enter a value for the edge sensor side position.
In the EDGE SENSOR ADJUST menu, select SENSOR ADJ VAL with the Up and Down
buttons, and then press the OK button.
Select ±XX.X  ±YY.Ymm with the Up and Down buttons, and then press the OK button.
±XX. X : Current value
±YY.: Value after change
Setting range: 10.0 to 20.0
Print sample
The adjustment value is the length of the
margin you have measured on the printout.
(Unit : mm)
>>>SENSOR ADJ VAL
 ±XX.X  ±YY.Ymm ◎
>>EDGE SENSOR ADJUST
 SENSOR ADJ VAL ◎
>>EDGE SENSOR ADJUST
 BACK FEED MEDIA ◎
>>EDGE SENSOR ADJUST
 FEED MEDIA ◎
BACKFEEDING MEDIA…
FEEDING MEDIA...
>>EDGE SENSOR ADJUST
 BACK FEED MEDIA ◎
>>EDGE SENSOR ADJUST
 FEED MEDIA ◎